Call us Toll free (800) 349-8313 or (818) 222-7191 | |
  Linear Supervised 5-Button, 8-Channel Handheld Transmitter DXS-25 | | Linear DXS-25 Supervised 5-Button, 8-Channel Handheld TransmitterThe Model DXS-25 Supervised 5-Button, 8-Channel Handheld Transmitter is a supervised, digitally coded radio transmitter designed for use with
Linear's DX and DXS Format receivers. Pressing a button on the transmitter sends a digitally coded wireless signal to its companion receiver.
To send a complete signal, press the transmitter button for a minimum of 2 seconds. The top button can be hidden with the top button cover
supplied.
The DXS-25 is a five-button, eight-code transmitter. Pressing any of the transmitter's front buttons sends codes one through
four. Holding down the small button on the transmitter's top together with pushing with any of the front buttons sends codes five through
eight.
The digital DXS code format features over a million possible codes. The DXS transmitters are precoded at the factory to unique
codes, so no field coding is required and can send a signal for up to 10 seconds per activation.
The DXS-25 is supervised for low
battery and sends hourly status reports. Some receivers are able to use these signals, others are not. Receivers must be programmed to the
transmitter code before system testing and operation. Refer to the receiver's instructions for details on operation and
programming.
Each DXS-25 is powered by two self-contained type 2032 3-volt lithium batteries (included). When the batteries voltage
gets low, a low battery report is sent with any alarm or status report to notify the receiver. The red LED will blink when the transmitter is
activated with low batteries.
A removable pocket clip and belt clip are provided for each transmitter. Either can be attached to the
back of the transmitter allowing the unit to be clipped to shirt pocket or slid onto a belt.
Features
- Complete RF supervision.
- Alarm, supervisory, and low battery transmissions.
- Unique "Extra" top button.
- High visibility operate LED.
- Lithium batteries supplied.
- Pocket/belt clip supplied.
|
- Dimensions: 4.2 in L x 1.6 in W x 0.8 in H (107 x 41 x 20 mm)
- Power: Two 3V DL-2032 lithium batteries (supplied)
- Current Consumption: Standby: 1 µA
- Alarm: 8 mA average while transmitting
- Battery Life: Five years typical
- Measured Range: 1,500 feet minimum, open air (four quadrant test into DXSR-1504)
- Channels: 8 channels - all individual buttons on the front of the transmitter (4 channels), plus top and then any front button (4 additional channels)
- Operating Frequency: 315 MHz
|
|
Special Order: All special order items require a 50% deposit of the total purchase value before ordering. Please call for lead times on special order items or request a quote by email or fax. Certain items such as, but not limited to, gate operators, telephone entry systems, card reader systems, access control systems, non-stock radio controls, and any item that has been specifically ordered for you are considered a special order items. All returns and cancellations within 30 days or exchanges within our 1-year warranty policy are subject to a 25% restocking fee. All warranties are void where evidence of misuse or abuse is present. Copyright © 2010 by Mega Access Controls Inc. All rights reserved. No part of this site can be reproduced in any form or by any means, electronic, mechanical, photocopying, or otherwise, without the prior written permission of Mega Access Controls Inc. |